Then Linus responded pretty poorly (and ended up stepping down as CEO and is now a chief creative something or other iirc)
Linus didn’t step down in response to this. I don’t remember the exact timelines, but he either stepped down before this, or was in already in the process of transitioning to the new CEO when this happened.
No. Modern SSDs are quite sophisticated in how they handle wear leveling and are, for the most part, black boxes.
SSDs maintain a mapping of logical blocks (what your OS sees) to physical blocks (where the data is physically stored on the flash chips). For instance, when your computer writes to the logical block address 100, the SSD might map that to a physical block address of 200 (this is a very simplified). If you overwrite logical block address 100 again, the SSD might write to physical block address 300 and remap it, while not touching the data at physical block address 200. This let’s you avoid wearing out a particular part of the flash memory and instead spread the load out. It also means that someone could potentially rip the flash chips off the SSD, read them directly, and see data you thought was overwritten.
You can’t just overwrite the entire SSD either because most SSDs overprovision, e.g. physically have more storage than they report. This is for wear leveling and increased life span of the SSD. If you overwrite the entire SSD, there may be physical flash that was not being overwritten. You can try overwriting the drive multiple times, but because SSDs are black boxes, you can’t be 100% sure how it handles wear leveling and that all the data was actually overwritten.
To native English speakers, yes. To non-native speakers, this is yet another bizarre rule they just have to memorize.
the timer has no idea if it was triggered during last boot. It only has the context of “this” boot, so it will do it right after a reboot and set a timer to start the service again after a week of uptime.
This is not correct. Persistent=true saves the last time the timer was run on disk. From the systemd.timer man page:
Takes a boolean argument. If true, the time when the service unit was last triggered is stored on disk. When the timer is activated, the service unit is triggered immediately if it would have been triggered at least once during the time when the timer was inactive.
OP needs to remove Requires=backup.service from the [] section so it stops running it when it start the timer on boot.
You have the timer requiring backup.service, so it will run that service every time the timer starts on boot. Remove Requires=backup.service, and that will fix the issue.
Well, for one, it’s network attached storage. If it’s not present in the network for one reason or another, guess what, your OS doesn’t boot… or it errors during boot, depending on how the kernel was compiled and what switches your bootloader sends to the kernel during boot.
Just use nofail in the fstab.
Second, this is an easy way for malware to spread, especially if it’s set to run after user logon.
If your fileshare is accessible to you, it is also accessible to malware running as your user. Mounting the share via a filemanager doesn’t change this.
All video codecs are lossy, meaning you will lose some quality. AV1 and H.265 are modern video codecs with the best quality to bitrate ratios, meaning you can get better quality for the same bitrate, or the same quality with a lower bitrate. The downside the these codecs is that they are very complex and computational expensive to do in software. You’ll want to make sure your GPU supports hardware encoding for the codecs you intend to record with. The reason most people will recommend AV1 over H.265 is that AV1 is royalty free. With H.265, companies have to pay a royalty to use H.265. Because of this, most companies (Netflix, YouTube, Facebook, Twitch, etc.) want to use AV1 going forward, meaning in the near future, it will probably be the dominant codec.